Vanities, Tile & Fixtures in Pembroke Park - Scope, Timeline & Cost
Vanities, tile & fixtures in Pembroke Park typically means replacing or upgrading three core elements of an existing bathroom: the vanity cabinet and countertop, wall and floor tile, and plumbing fixtures including faucets, showerheads, and accessories. Most jobs we handle here run 5 to 10 working days and fall in the $9,000-$28,000 range depending on material grade and whether plumbing stays in place. Call (844) 665-0162 for a free on-site estimate - we measure, spec, and price it in one visit.
How We Handle Vanities, Tile & Fixtures from Demo to Final Walkthrough
We’ve refined this into five clear stages so homeowners know what’s happening, what’s being decided, and when.
Stage 1: Protect and demo (Day 1)
We mask off the work corridor and adjacent rooms, then remove the existing vanity, mirror, lighting, fixtures, and tile. In Pembroke Park’s 1950s-1960s CBS homes, we often find original galvanized supply lines or cast-iron drains behind the walls - we document their condition before anything gets covered back up. This stage takes one day. You’ll need to have cleared the bathroom and confirmed your fixture and tile selections by this point.
Stage 2: Rough plumbing and electrical evaluation (Days 2-3)
With walls open, we pressure-test supply lines and scope drains. If you’re keeping the vanity and shower in their original positions, this is usually straightforward. Moving a vanity across the room or converting a tub deck to a walk-in footprint triggers a full rough-in rework, which adds 1-2 days and requires a plumbing inspection. We also verify that existing GFCI circuits can handle modern fixture loads - LED vanity bars and heated floors draw more than 1960s wiring was designed for.
Stage 3: Substrate prep and waterproofing (Days 3-5)
Concrete block walls in older Pembroke Park homes often have uneven surfaces from decades of tile-on-tile renovations. We grind flat, apply cement board or Schluter-Kerdi membrane depending on your tile choice, and flood-test shower pans for 24 hours. Floor prep includes self-leveling compound if we’re transitioning from small mosaic to large-format tile - anything over 15 inches demands a flatter substrate than these old slabs typically offer.
Stage 4: Tile and fixture installation (Days 6-9)
Wall tile goes up first, then floors, then grout. We install the vanity, connect plumbing, and mount fixtures. For vanities, we verify that your selected cabinet clears existing door swings and toilet clearances - a 60-inch double vanity in a 5-foot-wide 1960s bathroom often requires a custom depth or wall-hung configuration. Fixture trim gets installed and pressure-tested. This is where material lead times matter: imported tile or custom vanity finishes can push this stage out by 2-3 weeks if not ordered at contract signing.
Stage 5: Final inspection, cleanup, and punch list (Day 10)
We run every fixture through full hot/cold cycles, check grout consistency, and verify caulk lines at all wet-area transitions. If permits were pulled, the town inspector signs off before we close walls. You walk the space with our lead carpenter; anything that doesn’t match the approved spec gets noted and corrected within 48 hours.
The Material and Configuration Choices You’ll Make
Vanities, tile & fixtures in Pembroke Park involve more decisions than most homeowners expect. Here’s where your money goes and what each choice costs you in performance or maintenance:
- Vanity construction: plywood box vs. particleboard vs. solid wood. Plywood boxes with soft-close dovetail drawers run $1,200-$2,800 installed and survive humidity swings in South Florida bathrooms. Particleboard saves 30-40% upfront but swells at seam joints within 3-5 years. Solid wood fronts on plywood boxes split the difference for homeowners who want the look without the price.
- Countertop surface: quartz, solid surface, or natural stone. Engineered quartz (Cambria, Silestone, Caesarstone) resists etching and doesn’t require sealing - critical in hard-water Pembroke Park. Natural marble looks exceptional but needs annual sealing and shows water spots within weeks. Solid surface (Corian-type) repairs easily but lacks the depth of stone.
- Tile body: porcelain, ceramic, or natural stone. Porcelain with PEI rating 4+ handles the grit tracked in from coastal sand. Ceramic costs 20-30% less but chips at the edges in high-traffic baths. Natural stone (travertine, marble) demands sealed grout and more frequent maintenance - we only recommend it for powder rooms or master baths where homeowners accept the upkeep.
- Tile format: mosaic, subway, or large-format. Mosaics (2×2 or smaller) conform to old slab irregularities but require more grout lines to clean. Large-format (24×48 or plank) minimizes grout and looks contemporary, yet demands flatter substrates and costs more in labor due to precise leveling systems. Subway tile splits the difference and suits most Pembroke Park ranch-style homes.
- Fixture finish and valve type: chrome, brushed nickel, matte black, or living finishes. Chrome cleans easiest but shows water spots. Brushed nickel hides wear. Matte black makes a statement but can chip at edges on budget lines. We spec pressure-balanced valves minimum; thermostatic adds $400-$800 but holds temperature when a toilet flushes - worth it in homes with original 1-inch supply mains.
What Vanities, Tile & Fixtures Costs in Pembroke Park, FL
For the scope we described - vanity replacement, tile walls and/or floor, and new fixtures in an existing bathroom footprint - expect $9,000 to $28,000. Here’s what pushes a job toward the low or high end:
| Cost Driver | Low-End Scenario | High-End Scenario |
|---|---|---|
| Plumbing location | Vanity and shower stay put | Moving drain/vent/supply across room |
| Tile coverage | Vanity wall + floor only | Full surround to ceiling, niche, bench |
| Material grade | Stock vanity, ceramic tile, chrome fixtures | Custom vanity, porcelain slab, thermostatic valve |
| Substrate condition | Clean block, one tile layer | Multiple tile layers, wall rebuild, leveling |
| Permit scope | Cosmetic replacement, no permit | Rough plumbing, electrical, full permit + inspection |
Our written estimates include demolition, disposal, all materials, labor, and permit fees if required. What typically sits outside this base: water damage repair behind walls, asbestos abatement if we encounter old mastic, and any structural modification to accommodate a larger vanity or relocated fixtures. We flag these possibilities during the initial walkthrough so you’re not surprised.
Call (844) 665-0162 for an exact quote - estimates are free and we bring samples to the appointment.
What Pembroke Park Homes Specifically Do to This Job
Pembroke Park’s residential stock - small CBS homes from the 1950s and 1960s on slab foundations - shapes every vanities, tile & fixtures project we take here. These bathrooms were built to 1960s Florida codes: 5-foot widths, galvanized supply lines, and no exhaust ventilation beyond a window. The concrete block walls are solid and durable, but they’re rarely plumb after sixty years of moisture cycling, which means tile layout demands more labor than new construction.
Because Pembroke Park operates its own building department, permits for plumbing or electrical changes route through town hall rather than Broward County. Inspectors here know these older homes intimately and routinely flag unpermitted prior work once walls open - we’ve found everything from homeowner-spliced wiring to abandoned drain lines that were simply capped and tiled over. If your home has had prior “updates,” we budget extra time for discovery and potential rework.
The flat, low-lying coastal plain also means these slabs sit close to the water table. We never trench for drainage changes during summer months without dewatering plans, and we spec moisture-resistant backer board as standard - not an upgrade. For homeowners considering this work as part of a full Bathroom Remodeling in Pembroke Park, we coordinate the vanity, tile, and fixture phase with any structural or envelope work to avoid redundant inspections.
Serving Pembroke Park, FL - Our Local Coverage Area
We’re based in the Pembroke Park area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked - Vanities, Tile & Fixtures in Pembroke Park
Most jobs finish in 5 to 10 working days if materials are in stock and plumbing stays in its original location. Moving a vanity or shower location adds 2-4 days for rough-in work and inspection. Call (844) 665-0162 to schedule - we can confirm your timeline after seeing the space.
Cosmetic replacement of a vanity, tile, and fixtures on existing plumbing typically does not require a permit. Any relocation of supply or drain lines, electrical circuit additions, or wall modification triggers a permit through Pembroke Park’s building department. We determine permit scope during our first visit and handle all submittals.
Yes, and it’s the most cost-effective path. Keeping the vanity footprint, shower valve location, and toilet flange where they are eliminates rough-in labor and inspection delays. We still recommend replacing supply stops and escutcheons while walls are open - original 1960s valves in Pembroke Park homes often fail within a year of being disturbed.
The $9,000 job uses a stock 36-inch vanity, ceramic wall and floor tile within a standard layout, and chrome fixtures on existing valves. The $28,000 job includes a custom or double vanity, full porcelain slab or large-format tile to the ceiling, thermostatic and hand-shower fixtures, niche and bench details, and relocated plumbing with full permitting. Most Pembroke Park homeowners land in the $14,000-$20,000 range with mid-grade quartz tops and porcelain tile.
We warranty our installation workmanship for one year, which covers grout cracking, fixture leaks at our connections, and vanity installation integrity. Manufacturer warranties apply to the products themselves - typically 5-25 years on cabinets, lifetime on most fixture cartridges, and varying terms on tile. We register all manufacturer warranties on your behalf and provide documentation at final walkthrough.
Get Your Free Estimate for Vanities, Tile & Fixtures in Pembroke Park
Call (844) 665-0162 to schedule a free on-site estimate. Raymond Estevez or a member of our Bathroom Remodeling crew will measure your space, assess existing plumbing and substrate conditions, and bring material samples from our 50+ brand partnerships. You’ll receive a written, itemized estimate within 24 hours with no pressure to decide on the spot. Homeowners in Pembroke Park often pair bathroom updates with exterior work - if you’re also considering Tile Roofing in Pembroke Park or Specialty Roofing in Pembroke Park, we can coordinate both projects under one schedule and one point of contact.
Written by Raymond Estevez, Owner at Groundwork Construction Co., serving Pembroke Park and South Florida.