What Paver Driveways Cost and Involve in Sunrise, FL
A paver driveway installation in Sunrise typically runs $7,000-$18,000 for a standard two-car residential driveway, with most projects completed in 3-5 business days once materials arrive. You’ll choose between concrete pavers in different thicknesses, textures, and color blends, then we’ll handle demolition of your existing surface, base preparation, and final compaction. Call (844) 665-0162 and we can walk your property this week for a free, itemized estimate.
Sunrise’s older housing stock - much of it built during the 1970s and 1980s master-planned expansion - means we’re often replacing original concrete slabs that have cracked from decades of Florida heat cycling and seasonal water table shifts. The good news: a properly installed paver system with an open-graded base handles that expansion and contraction far better than monolithic concrete.
How We Install Paver Driveways - Stage by Stage
We’ve refined this process across hundreds of hardscape projects in Broward County. Here’s what actually happens, and what you’ll need to decide at each point.
Stage 1: Site Evaluation and Utility Marking (Day 1)
We measure your exact driveway footprint, check slope and drainage patterns, and verify whether your existing surface is concrete, asphalt, or shell. You’ll decide now if you want to maintain the current dimensions or expand toward the street or side yard. We call 811 for utility locates, which is mandatory before any excavation in Sunrise. This stage takes 2-4 hours on-site, though utility marking can take 48-72 hours to complete.
Stage 2: Demolition and Base Excavation (Day 1-2)
We remove your existing driveway material, typically 4-6 inches deep for a standard residential job. In Sunrise, we frequently hit sandy, moisture-retentive soils near the Everglades boundary, so we may need to excavate deeper and install additional geotextile stabilization. You’ll see the subgrade exposed here - if we find unexpected soft spots or buried debris from prior construction, we’ll flag it immediately before moving to base material.
Stage 3: Base Installation and Compaction (Day 2-3)
This is where quality separates itself. We lay open-graded crushed stone, usually #57 stone or similar, in 4-6 inch lifts, compacting each layer with a plate compactor to 95% standard Proctor density. For Sunrise’s wet-season exposure, we often specify a slightly thicker base course than the minimum ICPI standard. The base must shed water, not hold it. You’ll confirm the final grade at this point - we want positive drainage away from your garage and foundation.
Stage 4: Edge Restraint, Bedding Sand, and Paver Laying (Day 3-4)
We set heavy-duty aluminum or concrete edge restraints, spread 1 inch of coarse bedding sand, and begin laying pavers in your chosen pattern. Herringbone handles vehicle loads best; running bond or basketweave work for lighter-duty applications. In Sunrise, we typically stock Belgard, Tremron, and Techo-Bloc pavers through our Driveway & Pavers supply relationships, so you’re not waiting on special orders unless you want a custom blend.
Stage 5: Compaction, Joint Sand, and Final Inspection (Day 4-5)
We vibrate the pavers into the bedding layer, sweep polymeric sand into joints, compact again, and apply a final water activation to lock the sand. You’ll do a walkthrough with our crew lead to confirm pattern alignment, color consistency, and drainage flow. Most Sunrise permits require a final inspection for hardscape work over certain square footages, which we coordinate directly with Broward County Building Code Services.
The Paver Options You’ll Actually Choose Between
These aren’t abstract “good, better, best” tiers. Each choice has a specific performance implication for Sunrise’s climate and your usage pattern.
- Thickness: 60mm vs. 80mm pavers. Sixty-millimeter pavers handle standard passenger vehicles fine and cost less per square foot. Eighty-millimeter pavers are the right call if you have delivery trucks, RVs, or heavy equipment - the extra 20mm of material adds structural depth that resists edge chipping under point loads. For most Sunrise single-family homes, 60mm suffices; we recommend 80mm for shared driveways or commercial-adjacent properties.
- Surface texture: smooth, tumbled, or slate-embossed. Smooth finishes (like Tremron’s Olde Towne) clean easily but can be slick when algae builds up during our wet summers. Tumbled pavers have softened edges that hide wear and provide better barefoot traction if your driveway doubles as a play area. Slate-embossed textures offer the most grip but collect a bit more organic debris in the crevices.
- Color strategy: single batch, blended, or border accent. Single-color runs look intentional and modern but show every leaf stain and oil spot. Blended palettes - tan-charcoal-gray mixes common in Sunrise’s Mediterranean-influenced architecture - camouflage minor soiling. A soldier course border in a contrasting color defines the edge visually and makes future repairs less conspicuous if you ever need to pull and replace a section.
- Joint sand: standard silica vs. polymeric. Standard sand is cheaper upfront but washes out during our summer deluges, requiring annual re-sweeping. Polymeric sand binds when activated with water and resists both erosion and weed intrusion. For Sunrise’s rainfall pattern, polymeric pays for itself in maintenance reduction within two to three years.
- Permeable vs. traditional impervious installation. Permeable pavers with an open-graded base allow rainfall to percolate through, reducing runoff and helping with some HOA drainage requirements. They cost roughly 15-20% more and require periodic vacuuming to prevent clogging. In low-lying Sunrise areas with poor yard drainage, permeable systems can be a practical alternative to installing French drains.
What Paver Driveways Cost in Sunrise, FL
| Scope | Typical Range |
|---|---|
| Standard two-car driveway (400-600 sq ft), 60mm pavers | $7,000-$12,000 |
| Large driveway or expanded footprint (600-900 sq ft), 80mm pavers | $12,000-$18,000 |
| Demolition of existing concrete only | $1,200-$2,500 |
| Additional base depth / soil correction | $800-$2,000 |
| Permeable paver upgrade | +15% to +20% |
Five factors push your specific number up or down:
Existing surface condition. Asphalt rips out faster and cheaper than reinforced concrete. If your current driveway has a thickened edge or wire mesh, demolition labor increases.
Access constraints. Tight side yards, fence gates, or mature oak canopies in Sunrise’s established neighborhoods limit equipment size and may require hand-carrying materials.
Grade correction needs. Driveways pitched toward the garage or with low spots that pond water need regrading, which adds excavation and fill.
Material tier and pattern complexity. Basic running bond in a stocked color costs less than herringbone in a three-color custom blend requiring special order lead times.
Permit and inspection scope. Broward County requires permits for hardscape work exceeding certain coverage ratios; we pull these as part of our standard process, but the permit fee and inspection scheduling factor into timeline and cost.
Our written estimates include demolition, disposal, base materials, pavers, edge restraint, joint sand, compaction, and permit coordination. They do not include sprinkler repair (common if heads sit in the driveway path), landscape restoration beyond the immediate edge, or garage floor resurfacing if your old driveway was bonded to the slab.
What Sunrise Homes Specifically Mean for This Job
Sunrise’s development history shapes nearly every paver driveway we install here. The city was substantially built out in the 1970s and 1980s as a master-planned suburban community, meaning a large share of its residential infrastructure is now forty-plus years old. That matters for your driveway because original concrete from that era was typically poured without modern expansion joints or reinforcement standards, and it’s reaching end of service life simultaneously across whole neighborhoods.
We’re regularly in the older condo corridors along Sunset Strip and NW 44th Street, where Broward County’s 40-year recertification cycle has flagged buildings for structural review. While that’s primarily a structural repair issue, it creates a ripple effect: once a building undergoes remediation, owners and HOAs often reconsider the entire site hardscape, including parking areas and access drives. We’ve coordinated paver installations alongside these larger recertification projects, sequencing our work after structural repairs and before final landscaping.
The climate reality is equally specific. Sunrise sits inland adjacent to the Everglades water conservation areas, giving it a seasonally high water table that complicates any excavation work. Our wet season afternoon thunderstorms, roughly June through October, compress exterior construction schedules - we typically avoid base excavation during active tropical systems, and we may tent work areas during sudden downpours to prevent washout of uncompacted materials. The sandy, moisture-retentive soils also mean we specify geotextile fabric more consistently here than in coastal Broward cities with rockier subgrades.
Your HOA may have additional requirements. Several Sunrise communities specify paver color palettes or restrict permeable installations based on master drainage plans. We pull those documents during our initial evaluation so your design doesn’t stall at the architectural review committee.
Serving Sunrise, FL - Our Local Coverage Area
We’re based in the Sunrise area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked - Paver Driveways in Sunrise
Most residential paver driveway projects in Sunrise take 3-5 business days from demolition to final compaction, assuming materials are in stock and weather cooperates. Permitting adds 5-10 business days beforehand, and we avoid base excavation during active tropical weather from June through October. Call (844) 665-0162 and we’ll confirm current material availability and schedule your free estimate.
Yes, Broward County Building Code Services requires permits for hardscape work that exceeds certain lot coverage thresholds or involves demolition of existing impervious surfaces. We handle permit application, plan submission, and inspection scheduling as part of our standard project management. The permit fee is typically included in your written estimate.
Sometimes, but rarely without modification. Sprinkler heads and lateral lines frequently run through driveway edges in Sunrise’s older lots, and we typically need to relocate or cap at least a few heads to achieve proper base depth and edge restraint. We mark all irrigation components during Stage 1 and coordinate with your irrigation company if you prefer - or we can handle basic relocation ourselves.
Concrete patching costs less upfront but usually fails again within 2-4 years in Sunrise’s climate, while pavers cost $7,000-$18,000 installed but carry individual unit replaceability and better drainage. If your slab has widespread cracking, settlement, or drainage issues, pavers are typically the more economical 10-year solution. We can evaluate both options during your free estimate.
Our paver driveway installations carry a workmanship warranty covering base failure, settlement, and edge restraint separation for a period we specify in your written contract. The pavers themselves carry manufacturer material warranties through Belgard, Tremron, or Techo-Bloc against manufacturing defects. We don’t warranty against oil staining, surface wear from heavy equipment, or joint sand loss from pressure washing - we’ll explain maintenance expectations clearly before you sign.
Get Your Free Estimate for Paver Driveways in Sunrise
We’ll walk your driveway, check drainage and access, and deliver an itemized estimate with material options you can compare. No deposit required to schedule. Call (844) 665-0162 or reach out through our Sunrise service page. Homeowners exploring larger property improvements often pair hardscape work with our ADU Design & Permitting in Sunrise or Garage Conversion ADU in Sunrise services - we’re happy to scope multiple projects during the same site visit as part of a full Driveway & Pavers in Sunrise assessment.
Written by Raymond Estevez, Owner at Groundwork Construction Co., serving Sunrise and Broward County homeowners since our founding.