Patios, Walkways & Pool Decks in Lantana - Same-Day Service, Done Right the First Time

What Does a New Patio, Walkway or Pool Deck Cost and Take in Lantana?

Patios, walkways and pool decks in Lantana typically run $3,500-$11,000 for paver installations, with most projects completed in 5 to 10 working days depending on demo needs and permit timing. Call (844) 665-0162 and we’ll walk your property, confirm measurements, and email a written estimate within 24 hours.

Call (844) 665-0162

How We Build Patios, Walkways & Pool Decks in Lantana

Every hardscape job follows the same five stages, though the sequence shifts slightly when we’re tying into an existing pool coping or working around mature landscaping homeowners want to protect.

Stage 1: Site measure and utility locate (Day 1)

We mark sprinkler heads, pool plumbing, and any buried electrical runs. In Lantana’s older CBS neighborhoods, we also flag where original cast-iron sewer laterals may cross the yard. You’ll decide during this visit whether we’re matching an existing paver color or starting fresh. This takes 2-3 hours.

Stage 2: Demo and rough grade (Days 2-3)

Old concrete, pavers, or wood decking comes out. We haul off debris same-day to avoid the tight setbacks common on Lantana’s 50- and 60-foot lots near Ocean Avenue. Then we rough-grade, pitch everything away from the house and pool equipment, and compact the subgrade with a plate compactor in 8-inch lifts. Homeowner decision point: whether to relocate any irrigation heads now or cap them.

Stage 3: Base installation and edge restraint (Days 3-4)

We lay geotextile fabric, then spread and compact 4-6 inches of crushed concrete road base, depending on expected load. Pool decks get the thicker spec because of concentrated furniture weight and the freeze-thaw stress that still occurs in South Florida’s brief cold snaps. Edge restraints go in on mortar or spikes, and we check grade with a laser. You’ll approve the exact layout before we proceed.

Stage 4: Sand bedding and paver laying (Days 4-7)

One inch of coarse bedding sand, screeded flat. We lay pavers in your chosen pattern, cut border pieces with a wet saw, and check for lippage every few courses. For pool decks, we pay particular attention to the cantilever edge or bullnose coping detail, whichever matches your pool. This is where the job’s visual character gets locked in.

Stage 5: Compaction, joint sand, and seal (Days 7-10)

A plate compactor with a protective mat vibrates the pavers into the bedding layer. We sweep polymeric joint sand into gaps, mist it to activate the binder, and apply a breathable sealer if you’ve chosen that option. Final walkthrough with you on-site. We leave care instructions and touch-up sand.

The Material Choices You’ll Actually Decide Between

• Concrete pavers (standard 60mm): The workhorse option. Tremron and Belgard both manufacture lines rated for pool-deck use with textured, non-slip surfaces. Cost sits at the lower end of our range. Color fades gradually over 8-10 years in Lantana’s UV exposure; plan on resealing every 3 years to slow this.
• Thick pavers (80mm+): Heavier body, better for driveways but overkill for most patios unless you’re running equipment near the pool. We mention them because some Lantana homeowners with combined patio-driveway projects want visual continuity. Adds roughly 15-20% to material cost.
• Natural stone (travertine, limestone): Stays cooler underfoot than concrete, which matters on west-facing pool decks in Lantana’s afternoon sun. Higher material cost, more waste in cutting, and it requires a denser base because of irregular thickness. Best for homeowners prioritizing barefoot comfort and resale aesthetics.
• Porcelain pavers: Newer to the outdoor market. Extremely low water absorption, so they resist the salt-air staining that can mark up natural stone near the Intracoastal. Thinner profile means less elevation change where they meet existing doors. Limited local inventory can extend lead times by 2-3 weeks.
• Joint sand type: Standard masonry sand is cheaper upfront but washes out during Lantana’s summer downpours. Polymeric sand locks joints and inhibits weed growth. For pool decks specifically, we recommend polymeric because chlorine splash and deck drainage both accelerate joint erosion.
• Edge restraint method: Plastic edging on spikes works for patios with gentle curves. Concrete haunching is better for pool decks with straight runs and heavy furniture loads. We decide this with you based on layout, not habit.

What Patios, Walkways & Pool Decks Costs in Lantana, FL

Five variables push any quote toward the high or low end of these ranges:

Size and shape complexity. Straight rectangles lay fast. Radius cuts, inlays, or multiple elevation changes add labor hours fast.

Existing surface condition. Removing old concrete pool decking costs more than overlaying it, but overlaying limits your paver height and can trap moisture. We assess which path makes sense for your specific slab.

Access. Lantana’s older neighborhoods have narrow side yards and mature ficus hedges. If we can’t get a mini-excavator through a 4-foot gate, demo becomes hand-work, and that shows in the estimate.

Material grade and source. Imported travertine versus domestically manufactured concrete pavers can double material cost. We quote both when asked, never assume.

Permit and inspection scope. Standalone patios and walkways under 120 square feet often don’t trigger a building permit in Palm Beach County. Pool decks almost always do, especially if we’re altering the pool coping or drainage. Permit fees and the two required inspections add $400-$900 and 3-5 days to the calendar.

Our written estimates include demolition, disposal, base materials, pavers, edge restraint, joint sand, and standard compaction. They do not include tree removal, sprinkler repair, or pool equipment relocation. Those get separate line items if needed.

What Lantana’s Conditions Mean for Your Hardscape Project

Lantana’s position on the Intracoastal Waterway shapes this work in ways inland Florida towns don’t face. The salt-laden air here corrodes exposed metal fasteners within a few seasons, so we specify stainless steel or hot-dipped galvanized spikes and edge restraint hardware on every patio, walkway and pool deck we build in the 33462 ZIP. Standard zinc-plated hardware that holds up fine in Greenacres or Wellington turns orange here in eighteen months.

The housing stock matters too. Most Lantana homes were built between the 1950s and 1970s as concrete block stucco structures on compacted fill, not engineered slabs. Original patios and pool decks from that era were often poured thin, without reinforcement, and they’ve settled unevenly as fill compacted over decades. We see this most often in the neighborhoods between Ocean Avenue and the water, where the ground was marshier to begin with. Our prep stage includes checking for voids beneath existing concrete; if we find them, we inject flowable fill or break out and recompact rather than paving over a hollow spot that’ll crack your new surface in two years.

Then there’s the flood code. Because so much of Lantana sits in FEMA AE zones, any project that’s part of a larger renovation needs careful sequencing. A patio or pool deck by itself rarely triggers substantial improvement rules, but if you’re also doing full kitchen remodeling in Lantana or an addition in the same permit cycle, the combined assessed value can push you past Palm Beach County’s 50% threshold. When that happens, the project converts to new-construction flood compliance, and the finished floor elevation becomes a legal requirement, not a design preference. We pull the FEMA map and the property appraiser’s current assessed value before we price any multi-scope job in Lantana. It’s a five-minute check that prevents five-figure surprises.

Homeowners here often pair hardscape work with broader exterior updates. If you’re considering an accessory dwelling unit, our ADU site prep and utilities work in Lantana coordinates directly with patio and walkway installation to avoid tearing up finished surfaces later. And if your project is part of a full exterior transformation, our driveway and pavers work in Lantana uses the same material lots and joint sand for visual consistency across the property.

Our driveway and pavers crew handles patios, walkways and pool decks with the same process discipline we apply to every exterior surface. From driveway to roofline, one contractor manages every phase.

Frequently Asked - Patios, Walkways & Pool Decks in Lantana

Get Your Free Estimate for Patios, Walkways & Pool Decks in Lantana

Call (844) 665-0162 to schedule a site visit. Raymond Estevez or a member of our team will walk your property, confirm measurements, discuss material options, and email a written estimate within 24 hours. No deposit required to get on our schedule, and we don’t charge for the initial consultation anywhere in Lantana or the surrounding Lake Worth area.

Written by Raymond Estevez, Owner at Groundwork Construction Co., serving Lantana and South Florida homeowners.